Slide it in replacing the spacer and fix with the rear bolt, retighten the 4 bolts of the hitch if you have undone them to get the damper out. Make sure the new damper has the locating eye at 90 degrees so as to line up with the fixing bolt at the front, and the rear locating eye vertical to line up with the rear bolt. How do you replace a hitch damper on a caravan? Leaking fluid on the exterior of shocks or struts.The front end dives more than expected during hard braking.The Warning Signs Of Worn Shocks And Struts How do I know when my shocks need to be replaced? The Alko Stabiliser can be classified by its larger coupling head and red handle. Almost all caravans are braked.Īlko Stabilisers are typically found on caravans, as they help ensure there is enough distance between the caravan and your cars bumper. To know if your caravan is braked you have to check if it has a lever on the A-frame, and you have to look underneath it to see if there is a cable/rod that runs from the hitch to the coupling head. These stone chips can puncture as mention before however, they are an excellent indication of shock absorber wear. The tell-tale signs of a worn shock absorber is the degree of stone chips. If your shock absorber pulls open easily then it needs replacement. To test compression simply pull the open then push closed. Typically, this will be two friction pads on either side of the tow ball. The tow ball clicks into the place and you then push down the clamp handle which forces friction pads against the tow ball. The old Westfalia and the modern AL-KO/Winterhoff stabiliser hitch heads all work on the same principle. If the spring is too strong and the damper too stiff, the brakes could fail to operate with sufficient force to bring the caravan to a safe stop. The coupling damper has a shock-absorbent effect, reducing the ‘bouncing’ of the sprung drawbar. If it slides in and out very easily, or stays in when pushed in you need a new one. Try to push the coupling back into the A frame, a lot of resistance should be felt (if you can move it at all) and if you do manage to push it in, it should slowly return to its original position by itself.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |